FIGURE 1A
Figure 1B
4. Drive the ring of stakes
(included in the kit) as shown
in the instruction manual.
5. Wall assembly comes next!
It would be helpful to ask for
additional help for this part!
Figure 1C
6. Once the
walls are set you may now begin
to level the pool. Use a transit
level, which may be rented at a
local tool rental store. You can
also buy a water level online.
These are usually around $30.00.
7. After the
walls are level, install the
3/8” rebar as per the
instructions included in your
kit.
8. Check the
edge of the pool walls for
proper curve and adjust as
needed per the instructions in
your kit.
9. Pour 6” of
concrete in the 1 ½’ of the
remaining hold behind the pool
walls.
10. Install the
coping and aluminum liner track.
11. Cover the
pool wall with the roll of foam
liner provided.
12. Spread brick
mason sand over the pool floor
and smooth according to the
directions provided in your
installation manual. (See fig.
2)
FIGURE 2
13. Drop in the
pool liner and pull it into
place with a shop vacuum. (see
fig. 3)
FIGURE 3
14. Start
filling the pool!
15. Run piping.
16. Backfill the pool as the
water comes up. You may do this
by hand or with a tractor,
making adjustments to the walls
as needed. (See fig. 4)
FIGURE 4
17. Set the
forms and pour the concrete
sidewalks, decking or whatever
you desire!
18. NOW GET TO WORK
ENJOYING YOUR AMERICAN FUN
POOL!!!!!!
